User`s guide

General Rules
Before making any connections to the Modem, note the following rules:
• Ethernet Port (RJ-45)
All network connections to the Modem Ethernet port must be made using Category 5 UTP for 100Mbps; Category 3,4 UTP for
10Mbps
No more than 100 meters of cabling may be use between the MUX or HUB and an end node.
• VDSL Port (RJ-11)
All Home network connections to the RJ-11Port made using 24~26 Gauge phone wiring.
• We do not recommend using 28 Gauge or above phone line.
Connecting the Modem
The Modem has one Ethernet port which support connection to Ethernet operation. The devices attached to these ports must support
auto-negotiation or 10Base-T or 100Base-TX unless they will always operate at half duplex.
Use any of the Ethernet ports to connect to devices such as HUB, IP DSLAM, bridge or router. You can also connect to another
compatible Modem to an RJ-45 port on the other device.
The RJ11 Line port are use to connect to the wall RJ-11 modular socket which is connect to VDSL Switch or VDSL Modem CO side
The RJ11 Phone port of the Modem can connected to a telephone and a computer sharing one telephone wire for making calls and
accessing the internet at the same time.
6