User`s manual

VDSL2 CO&CPE Modem USER’S MANUAL Ver.A9
Return to the catalogue.
6
General Rules
Before making any connections to the VDSL2 CO/CPE MODEM, note the following rules:
Ethernet Port (RJ-45)
All network connections to the Modem Ethernet port must be made using Category 5 UTP for 100Mbps;
Category 3,4 UTP for 10Mbps
No more than 100 meters of cabling may be use between the MUX or HUB and an end node.
Phone Port (RJ-11)
All Phone set connections to the RJ-11 Port made using 24~26 Gauge phone wiring.
Connecting the VDSL2 CO/CPE MODEM
The VDSL2 CO/CPE MODEM can be controlled by a PC, henceforth, called the "Control PC". For this purpose, you
need
a PC with an Ethernet network interface and a DB-9 RS232 serial interface. Two programs are required: A Web
browser is mandatory and a terminal program should be available optionally.
The board has several connectors.
• 4 Ethernet RJ45 jacks (connect LAN devices to route); the Auto MDIX feature of the ports switches
automatically between MDI and MDI-X (MDI = Media Dependant Interface), therefore straight Ethernet cables
can be used.
• 2 x RJ11 jack (LINE Port is for connects VDSL client side to Line Interface, Phone port is for connects phone set
or FAX machine)