User`s manual

VDSL2 CO&CPE Modem USER’S MANUAL Ver.A9

Return to the catalogue.

2. Installation

Hardware Installation

This chapter describes how to install the VDSL2 CO/CPE MODEM and establishes network connections. You may

install the VDSL2 CO/CPE MODEM on any level surface (e.g, a table or shelf). However, please take note of the

following minimum site requirements before you begin.

2.1 Pre-installation Requirements

Before you start actual hardware installation, make sure you can provide the right operating environment, including

power requirements, sufficient physical space, and proximity to other network devices that are to be connected.

Verify the following installation requirement:

 Power requirements: DC12V/1A or above.

 The VDSL2 CO/CPE MODEM should be located in a cool dry place, with at least 10cm/4in of space at the front

and back for ventilation.

 Place the VDSL2 CO/CPE MODEM out of direct sunlight, and away from heat sources or areas with a high

amount of electromagnetic interference.

 Check if network cables and connectors needed for installation are available