User`s manual

VDSL2 CO&CPE Modem USER’S MANUAL Ver.A9

Return to the catalogue.

7.2.5.1 LAN Settings

Attention: For the VDSL2 CO/CPE MODEM it is recommended to select a simple IP setting suitable to controlled lab

environments. Set a static IP address and don’t use DHCP. The required steps are explained in Chapter 4.4

on Page 14!

To configure the LAN interface, click on the LAN Settings link in the left navigation bar. A screen is displayed as shown in

Figure 7.2.5.1 in case of the VDSL2 CO/CPE MODEM kit..

Figure 7.2.5.1 LAN Settings

The screen contains the following details:

Fields in LAN Settings

Field Description

IP Address Enter the LAN interface IP Address of VDSL2 CO/CPE MODEM.

Subnet Mask Enter the LAN Subnet Mask of VDSL2 CO/CPE MODEM.

The Gateway acts as DHCP

Server

Enable or disables the DHCP Server of the VDSL2 CO/CPE MODEM.

Select the check-box to enable this option.

• Click CANCEL to exit from this page without saving the changes.

• Click APPLY to save the information that has been entered.