User`s manual

VDSL2 CO&CPE Modem USER’S MANUAL Ver.A9

Return to the catalogue.

4.4 Select LAN

The menus below will not be used very often. But when connecting the VDSL2 CO/CPE MODEM to a new control

PC, you may want to go through the following steps in order to make the IP address previously set by ifconfig in the

terminal console permanent. Or on some later occasion you may want to change it again without using the console.

Then the menu below will help you too.

In order to set the IP address, click on “LAN Settings”.

Figure 4.4 LAN menu