User manual

Dynamix DW-Phone LP-201 SIP IP Phone

User Manual

12. [sysconf] command

1. -print: display all current configurations.

2. -idtime: set the duration (in second) of two pressed digits in dial mode as timed out.

If after the duration user hasn’t pressed next number, Dynamix DW-Phone LP-

201 will dial out all number pressed.

3. –service: set SIP Phone to work as normal mode or hotline mode. If user wants to

use hotline function, please set service to be 1, and set bureau related configuration.

Please refer to 19. [bureau] command.

4. -keypad: set DTMF type. User can select DTMF type Dynamix DW-Phone LP-201

receive and transmit. (sysconf –keypad 0/1, 0 for in band, 1 for RFC2833, 2 for

SIP-Info.)

5. -2833type: change RFC2833 Payload type.

6. -eod: select end of dialing key, e.g. set end of dial key as “＊” button, after finished

pressing dialing number then press “＊” will dial out. (sysconf –eod 0/1/2 , 0 for no

end of dial key , 1 for “＊” button, 2 for “#” button )

7. –service: set SIP Phone to be normal mode or under hotline mode.

(sysconf –service 0/1, 0 for normal service, 1 for hotline service.)

Note:

To set Dynamix DW-Phone LP-201 as hotline mode, user has to set Dynamix

DW-Phone LP-201 as Peer-to-Peer mode, and hotline table under bureau

command.