User manual

Dynamix DW-Phone LP-201 SIP IP Phone
User Manual
Chapter 2 Configuring the Dynamix DW-Phone LP-201
through
LCD Phone menus
Note:
1. After any configuration is made for the SIP-Phone, user has to do Reboot in the
selection 7 “Reboot”.
2. We suggest user to set IP address via LCD menu 5 → 2.3.4.5 first, then go to
chapter 3 to do other detail configurations via web browser.
1. Initialize SIP-Phone
1. When power on the SIP-Phone, the LCD screen shows as below. Now Dynamix DW-
Phone LP-201 is running Boot sector program.
IP-Phone
Board Start Booting
2. When Dynamix DW-Phone LP-201 finishes boot program initialization. User can see
flashing greeting as below:
System Initializing…………..
3. Then Dynamix DW-Phone LP-201 get into standby mode:
SIP-Phone
Proxy 10:10:10 AM
The main LCD screen would be shown as similar as above. “Proxy” means the
Dynamix DW-Phone LP-201 is in Proxy Mode, and when Dynamix DW-Phone LP-201
is connected to SNTP server, on LCD will show current time captured from SNTP
server.
4. When Dynamix DW-Phone LP-201 is under peer-to-peer mode, on LCD will show
“P2P” instead of “Proxy”.
SIP-Phone
P2P 10:10:10 AM
14