User manual

Dynamix DW-Phone LP-201 VoIP Phone
MESSAGE and its indicated LED light: When missed incoming calls, the MESSAGE
LED will be flashing. User can check the information of missed calls by pressing the
MESSAGE button.
TRANSFER:
1. Transfer a call by H.450 transfer function. Press TRANSFER button in
communication and press phone number which user want to transferred to can
transfer this call.
2. Change characters to be capital or lowercase: when pressing TRANSFER before
press letters can switch type of letters.
REDIAL: Redial the last outgoing call.
+ And -: Adjust the voice volume in communication.
SPEAKER: Speaking without picking up handset.
Note: All function keys mentioned above (except Number 1 –10, SPEAKER* and #)
are effective only in IP Phone mode.
2.Back View
DC 9V: DC 9V power input outlet
LAN: RJ-45 connector, connected directly to the Hub through the straight CAT-5
cable.
PC: RJ-45 connector, connected directly to the PC through the straight CAT-5 cable
Line: RJ-11 connector, connected directly to the PSTN analog line.
Note: There are two LED indicated lights: LINK/ACT and 10/100 for LAN port and PC port.
When network status is in normal, LED of LINK/ACT will be flashing; when transmit rate is in
10 mbps/100mbps, LED of 10/100 will light off/on.
6