User manual

Dynamix DW-Phone LP-201 VoIP Phone

IP Packet ToS information:

Signaling Packet:

DSCP Code: 10 <====== Configure control signal DSCP code

Media Packet:

DSCP Code: 10 <====== Configure RTP (voice) DSCP code

usr/config$

Or, the ToS function can be configured via Web Browser selection by entering the

above DSCP Decimal Code.

This command is for setting IP packet TOS values to determine IP Packets priority on

network.

1. -print : display current TOS values configurations.

2. -sigtype: configure DSCP value of signaling packets from 0 to 63

3. -rtptype: configure DSCP value of RTP packets from 0 to 63

Note:

1. This command won’t be functional until network environment can be

capable with TOS function.

2. tos -rtptype 14 -sigtype 10 is top priority of package.

16. [tone] command

Dynamix DW-Phone LP-201 is configurable of busy tone, PSTN call waiting tone (When

Dynamix DW - Phone LP-201 is in communication with IP mode and has PSTN incoming

call) and dial tone.

Usage ： tone –busy/pstncwt/dialtone “low frequency” “high frequency” “low

frequency level” “high frequency level” “low frequency on time” “low frequency

off time” “high on time” “high frequency off time”; user must key in 8 sets of

number to finish this configuration. If it is single-frequency tone, please set high