User manual

Dynamix DW-Phone LP-201 VoIP Phone

12. [sysconf] command

This command displays the system information and configuration.

1. -print: display system overall information and configuration.

2. -plan: It is for setting dial-numbering plan. While user will dial out e164 number only

for three digits, the plan can be set as 3. Once input 3 digits, Dynamix DW - Phone

LP-201 VoIP will immediately dial out. The plan 0 is for any possible digits use, when

after inter digit timed, Dynamix DW - Phone LP-201 VoIP will dial out the number no

matter how many digits user input.

Note: Before change to Peer-to-Peer mode from GK mode, please remember to set

dial plan as 0, or it may works not normally in P2P mode.

3. -keypad: set DTMF type .User can select DTMF type Dynamix DW - Phone LP-201

IP Phone receive and transmit.(sysconf –keypad 0/1/2/3 , 0 for in band ,1 for H.245

alphanumeric, 2 for H.245 signal type, 3 for Q.931 user info, 4 for RFC2833.)

4. -idto: set the duration(in second) of two pressed digits in dial mode as timed out. If

after the duration user hasn’t pressed next number, Dynamix DW - Phone LP-

201 VoIP will dial out all number pressed.

5. -eod: select end of dialing key, e.g. set end of dial key as OK button , after finished

pressing dialing number then press OK will dial out. (sysconf –eod 0/1/2/3 , 0 for no

end of dial key , 1 for “OK” button , 2 for “#” button , 3 for “＊” button )

6. -h450: Enable or disable H.450 related features, which include transfer, hold and

forward. Please Note that disable this function will cause TRANSFER button lost

function of switching characters to be lower or upper case.