User manual

Dynamix DW-Phone LP-201 VoIP Phone
8. [ping] command
Command ping can test which the IP address is reachable or not.
Usage: ping “xxx.xxx.xxx.xxx(IP address)”
The message will display packets transmitting condition or no answer from the IP
address.
9. [pbook] command
The command is for Peer-to-Peer Mode use only. Therefore, VoIP products such as
Dynamix DW-Phone LP-201 VoIP that support Peer-to-Peer Mode are also
available to be addressed on the Dynamix DW-Phone LP-201 phone book.
1.-print: display phone book data. User can print all data in phone book by command
(pbook –print). Furthermore, user can also print only a section of data by indicate
parameter 'start_record' and 'end_record' (pbook –print “start prefix” “end
prefix”). If parameter 'end_record' is omitted, only record 'start_record' will be
display (pbook –print “start prefix”).
2.-add: add a new record in phone book table by give a name and e164 number for the
Gateway / Terminal IP address .
(pbook –add name “X” ip “xxx.xxx.xxx.xxx” e164 “X”)
User can set IP or URL address( Domain Name Server must be configured. Please
refer to 4.6 [ifaddr] command)
3. -search: search any record such as ip address, name and e164 addressed on the
phone book.
4. -delete: delete a record with index listed in phone book table. (pbook –delete
“index number”)
5. -insert: insert an record in specified index of phone book.
6. -modify: modify any record that has addressed to index number. The name, IP
address and e164 number should be modified together in one modify command.
(pbook –modify “index” name “X” ip “xxx.xxx.xxx.xxx” e164 “X”)
Note: Please dial “#” after dial e.164 of pbook.
50