User manual

Dynamix DW-Phone LP-201 VoIP Phone

5. [commit] command

Save any changes after configuring the Dynamix DW-Phone LP-201 .

6. [ifaddr] command

Configure and display the Dynamix DW-Phone LP-201 IP information.

1. -ip, -mask, -gate: Set Dynamix DW-Phone LP-201 IP Address, subnet mask and

default gateway respectively.

2. -dhcp: When DHCP function enables (ifaddr –dhcp 1), Dynamix DW-Phone LP-201

will automatically search DHCP server after execute the commit and reboot

command. Note: After Dynamix DW - Phone LP-201 IP Phone catches a dynamic IP

address form DHCP server, user can see this IP address on LCD connect

configuration.

3. -sntp: When sntp server is available, enable Dynamix DW-Phone LP-201 SNTP

function and point to sntp server IP address. (ifaddr –sntp 1 “xxx.xxx.xxx.xxx”)

4. -dns: User can set Domain Name Server IP address. Once Dynamix DW - Phone

LP-201 VoIP can connect with DNS server, user can specify URL address instead of

IP address for Gatekeeper and phone book IP address. (Please refer to 4.13 [h323]

command and 4.9 [pbook] command)

5. –timezone: User can set different time zone according to the location Dynamix DW -

Phone LP-201 VoIP is. For example, in Taiwan the time zone should be set as 8,which

means GMT+8. (GMT-8: ifaddr –timezone -8)

6. -ipsharing: If Dynamix DW-Phone LP-201 is behind a IP-sharing , user can

enable IP sharing function and specify public IP address.(ifaddr –ipsharing 0/1

“public IP address of IP sharing” , 0 for disable and 1 for enable)

7. –ipchange: If user uses NAT device which supports multiple public IP address, and

Dynamix DW - Phone LP-201 VoIP enables IP change function, Dynamix DW -

Phone LP-201 VoIP will register to Gatekeeper with the public IP Dynamix DW -

Phone LP-201 VoIP uses but not the IP NAT uses.