User manual

Dynamix DW-Phone LP-201 VoIP Phone
(4) Indicate file name
User has to press the file name of new application rom file prepared for
upgrading
(5) Start Download
Press OK to start download new application rom file. After download is
finished, Dynamix DW - Phone LP-201 IP Phonewill automatically reboot.
(6) Firmware Version
Show versions of all rom files and hardware.
Note:
1.Download via LCD command can only upgrade new application rom file.
2.If Dynamix DW - Phone LP-201 IP Phonefails to upgrade via LCD menu,
Dynamix DW - Phone LP-201 IP Phonewill automatically reboot.
4. Hardware Test
Dynamix DW-Phone LP-201 provides self-test for all functions buttons. Once
user press hardware test selection, Dynamix DW - Phone LP-201 VoIP will
start testing programs. Please follow the direction from LCD panel to operate
and complete whole procedure.
5. PPPoE Configuration
(1) PPPoE Mode
Choose ON or OFF to enable or disable PPPoE function.
(2) Username And Password
Set PPPoE authentication user name and password.
(3) Retry When Disconnect
Choose ON or OFF to enable or disable this function. If user enables this
function, after PPPoE being disconnected, Dynamix DW - Phone LP-201 IP
Phonewill automatically reboot to re-connect, and after reboot, if Dynamix
DW - Phone LP-201 VoIP still can’t get contact with server, Dynamix DW -
Phone LP-201 VoIP will keep trying to connect. On the other hand, if user
disables this function, Dynamix DW - Phone LP-201 IP Phonewon’t reboot
and keep trying to connect.
6. Reboot
It is necessary and important for user to reboot it after any configurations has
been made to the Dynamix DW-Phone LP-201 .
17