User manual

Dynamix DW-Phone LP-201 VoIP Phone
Chapter 2 Configuring the Dynamix DW-Phone LP-201 through
Phone
menus
Note:
1. After any configurations be made for the LAN Phone 101/201, user has to do
Reboot in the selection 1 → 6 “Reboot”.
2. We suggest user to set IP address via LCD menu 1 → 1 first, then go to chapter
3 to do other detail configurations via web browser.
1.Initialize Dynamix DW-Phone LP-201
1. When power on the Dynamix DW-Phone LP-201 , the LCD screen shows as below.
Now Dynamix DW-Phone LP - 201 is running Boot sector program.
IP-Phone
Board Start Booting
2. Wait around one minute until the Dynamix DW-Phone LP-201 finishes boot program
initialization.User can see flashing greeting as below:
System Initializing…………..
3. Then Dynamix DW - Phone LP-201 IP Phoneget into standby mode:
IP-Phone
GK 10:10:10 AM
The main LCD screen would be shown as similar as above. The GK word means the
Dynamix DW-Phone LP-201 is in Gatekeeper Mode, and when Dynamix DW - Phone
LP-201 IP Phoneis connected to SNTP server, on LCD will show current time from
SNTP server.
4. After pressing the PSTN button, the GK word will be replaced by PSTN. Then Dynamix
DW - Phone LP-201 IP Phoneis in PSTN Mode. Please notice that in PSTN mode user
must plug PSTN line
in RJ-11 port.
IP-Phone
PSTN 10:10:10 AM
12