User Manual

6 www.DynamiteRC.com
Dynamite Vision Ultra AC/DC Charger
2. Choose the appropriate connector to t
your battery plug. Connect the red banana
plug to the red (+) positive terminal on the
front of the charger and the black banana
plug to the black (-) negative terminal.
WARNING: Always make sure that
you follow proper polarities at all times or
electrical shock will occur.
The use of a Li-Po bag (DYN1400 small-
DYN1405 large) is recommended for
charging Li-Po batteries to help prevent fire
in the event of a battery failure.
3. Press the “arrow” buttons to choose a
memory function to modify.
4. Press the “Mode” button to enter the
adjustment screen within 2 seconds or the
screen will automatically move back to the
charge screen. A curser will illuminate under
the memory digit acknowledging you have
entered the adjustment mode.
5. Press the “up” or “down” button to adjust
the charge current.
CAUTION: See the charge rate
charge for recommended charge currents.
Do not charge cells smaller than sub-C
cells over 2 amps or damage to the
charger or battery may occur. Li-Po
batteries should be charged no more than
a 1C rate e.g., a battery with a capacity of
5200mAh should not be charged at a
charge rate higher than 5.2 amps.
Battery Capacity Charge Rate Charge Time
600mAh 0.6A 60–80 Min.
1300mAh 1A 78–94 Min.
1800mAh 2A 54–65 Min.
3300mAh 5A 40–48 Min.
6. Press the “Set” button to scroll through the
chemistry selections.
CAUTION: Charging Li-Po
batteries under any other mode will
damage the battery, charger and may cause
fire. Always confirm the battery chemistry
setting prior to entering the charge mode.