User Manual

6 www.DynamiteRC.com
Dynamite Vision LED AC/DC Charger
2. Choose the appropriate connector to t
your battery plug. Connect the red banana
plug to the red (+) positive terminal on the
front of the charger and the black banana
plug to the black (-) negative terminal.
NOTICE: Always make sure that you
follow proper polarities at all times.
3. Press the “mode” button to choose the
number of cells that matches the battery that
will be charged.
4. Press and hold the “mode” button to change
the charge rate. Release the “mode” button
when the LED matching your selected charge
rate is on.
CAUTION: See battery pack
manufacturer’s or vendors’ specific
charging rate instructions for charging. If
charging current rate is not available, we
recommend a charge current rate of 1C or
less. (e.g., 1 x 1500mAh / 1h = 1500mA or
1.5A). Do not charge cells smaller than
sub-C cells over 2 amps or damage to the
charger or battery may occur.
Battery Capacity Charge Rate Charge Time*
1500mAh 1.5A 60–80 Min.
3300mAh 3A 66–86 Min.
5000mAh 5A 60–80 Min.
* Charge times based on fully discharged
batteries.
5. Connect the battery to the charge lead.
Press the “Start” button once to begin
charging.
The Start button can be pressed at any
time to stop or resume charging.
The Charge Level LED’s indicate how
close the battery is to being fully charged.