Vision LED AC/DC Charger Operation Manual www.DynamiteRC.
This is a sophisticated hobby product and NOT a toy. It must be operated with caution and common sense and requires some basic All instructions, warranties, and other mechanical ability. Failure to operate this collateral documents are subject to change Product in a safe and responsible manner could at the sole discretion of Horizon Hobby, Inc. result in injury or damage to the product or For up to date product literature, visit http:// other property. This product is not intended for www.horizonhobby.
Product Support For technical assistance with this product, please contact the appropriate Horizon Product Support office. See page 10. Specifications Input: AC 110 to 240V DC 11.5 to 15V Battery Type: Ni-Cd or Ni-MH Features Setup mode and write memory. DC input reversed polarity protection. Battery Pack reversed polarity protection. Internal Safe-Time: 120 minutes. LED Functions Battery Cell: Ni-Cd/Ni-MH; 4- to 8-Cell (4.8V to 9.
Available Charge Cords and Adapters The Vision LED includes the Tamiya style charge cord (DYN5005). Dynamite offers charge cords and adapters for all your battery charging requirements. See the list below to order additional connectors.
DC POWER If you power the charger by using DC power, connect the red (positive) end of the alligator clips to the red terminal of the DC power source and the black (negative) end of the alligator clips to the black terminal of the DC power source. DYN5008 Charge Adapter Banana: EC5 Female NOTICE: Always make sure that you follow proper polarities at all times. CAUTION: Never connect the AC and DC input cords to an active power source at the same time.
CAUTION: See battery pack manufacturer’s or vendors’ specific charging rate instructions for charging. If charging current rate is not available, we recommend a charge current rate of 1C or less. (e.g., 1 x 1500mAh / 1h = 1500mA or 1.5A). Do not charge cells smaller than sub-C cells over 2 amps or damage to the charger or battery may occur. 2. Choose the appropriate connector to fit your battery plug.
WARNING: If at any time during the charge process the battery pack(s) become hot (over 140 degrees F), unplug the battery immediately and discontinue the charge process. OTHER WARNINGS AND PRECAUTIONS Failure to exercise caution while using this product and comply with the following warnings could result in product malfunction, electrical issues, excessive heat, FIRE, and ultimately injury and property damage.
• Always inspect the battery before charging. Warranty and Repair Policy • Always terminate all processes and contact Horizon Hobby if the product malfunctions. Warranty Period • Always keep batteries and charger away from any material that could be affected by heat (such as ceramic and tile), as they can get hot. Exclusive Warranty- Horizon Hobby, Inc.
(c) Purchaser Remedy- Horizon’s sole obligation hereunder shall be that Horizon will, at its option, (i) repair or (ii) replace, any Product determined by Horizon to be defective. In the event of a defect, these are the Purchaser’s exclusive remedies. Horizon reserves the right to inspect any and all equipment involved in a warranty claim. Repair or replacement decisions are at the sole discretion of Horizon.
Warranty Inspection and Repairs To receive warranty service, you must include your original sales receipt verifying the proofof-purchase date. Provided warranty conditions have been met, your Product will be repaired or replaced free of charge. Repair or replacement decisions are at the sole discretion of Horizon Hobby.
Dynamite Vision LED AC/DC Charger www.DynamiteRC.
©2010 Horizon Hobby, Inc.
