User Manual

6 www.DynamiteRC.com
Dynamite Vision LCD AC/DC Charger
2. Choose the appropriate connector to t
your battery plug. Connect the red banana
plug to the red (+) positive terminal on the
front of the charger and the black banana
plug to the black (-) negative terminal.
NOTICE: Always make sure that you
follow proper polarities at all times.
3. Press the “mode” button until Amps are
shown on the LCD screen. Use the “up” or
“down” buttons to set your charge rate.
CAUTION: See battery pack
manufacturer’s or vendors’ specific
charging rate instructions for charging. If
charging current rate is not available, we
recommend a charge current rate of 1C or
less. (e.g., 1 x 1500mAh / 1h = 1500mA or
1.5A) Do not charge cells smaller than
sub-C cells over 2 amps or damage to the
charger or battery may occur.
Battery Capacity Charge Rate Charge Time*
600mAh 0.6A 60–80 Min.
1300mAh 1A 78–94 Min.
1800mAh 1.8A 60–80 Min.
3300mAh 3.3A 60–80 Min.
* Charge times based upon a fully discharged
battery.
4. Press the “Mode” button once to change
the screen to voltage. Pressing the “up” or
“down” button will allow you to set the cell
count to match your Ni-Cd/Ni-MH battery.
5. Connect the battery to the charge lead.
Press “start” to begin charging.
The Start button can be pressed at any time to
stop or resume charging.
6. During charging, pressing the “mode” button
will cycle through the screens, providing
information regarding your battery.
Battery Charge Status Icon:
The Battery Charge Status Icon appears in the
lower right corner of the LCD in all modes. This
icon indicates how close the battery is to being
fully charged.