PROPHET PLUS™ LCD AC/DC–Powered Peak Prediction Charger for 4- to7-cell Ni-Cd and Ni-MH Battery packs INSTRUCTION MANUAL ©2010 Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, IL 61822 USA Dynamite® products are distributed exclusively by Horizon Hobby, Inc. www.dynamiterc.com Revised 12/09 6394.
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com/ProdInfo/Files/dyn4033-manual.pdf.
Features DC Power If you power the charger by using DC power, connect the red (positive) end of the alligator clips to the red terminal of the DC power source and the black (negative) end of the alligator clips to the black terminal of the DC power source. WARNING: Always make sure that you follow proper polarities at all times or electrical shock will occur.
. Push the Start button to begin the charge process. Move the LCD selector switch to the ammeter position. Select a charge rate below 2 amps, depending on what receiver pack you are going to charge. Charge 600mAh receiver packs at 1 amp or less, while higher capacity packs, such as 1000mAh, can be charged at 2 amps. 5. Once you have begun to charge the battery pack, the charge status LED will go from flashing to solid red and the LCD will display ”fast.” 6.
Questions, Assistance, and Repairs Your local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or use of the Product has been started, you must contact Horizon directly. This will enable Horizon to better answer your questions and service you in the event that you may need any assistance. For questions or assistance, please direct your email to productsupport@horizonhobby.com or call 877.504.0233 toll free to speak to a Product Support representative.
10 11
