User Manual

ManualsBrandsDynamite ManualsHobbyPit Peak 4/5 C Receiver Peak Charger

Thank for you purchasing the Pit Peak

DC Peak charger. This charger will safely

charge virtually all 4/5 cell Ni-Cd and

Ni-MH receiver packs. It continuously

monitors the battery’s charge curve and

calculates when the peak will occur

(100% charge), then stops fast charging

at that point. This feature helps to

protect Ni-Cd and especially Ni-MH cells,

which are very sensitive to heat. After

the battery has peaked, the charger

automatically transitions to trickle

charge, keeping the battery pack fully

charged until you are once again ready

to use it.

• Peak detection circuitry

• 1.5-amp charge rate

• Alligator clips for DC operation

• Universal charge lead with BEC adaptor

allows virtually all 4/5 cell receiver

packs to be charged

• Simple push-button operation

This charger is powered by using the

provided alligator clips to connect the

charger to a 12V DC power source, such

as a 12V hobby battery (HAN102) or an

automobile battery.

Connect the red (positive) alligator clip

to the red terminal of the DC power

source and the black (negative) alligator

clip to the black terminal of the DC

power source. If you choose to power

this charger with an automobile battery,

never do so with the automobile running!

When power is supplied to the charger

correctly, the charger will beep.

1. Connect the receiver battery lead to

the charger. The charger will beep and

the LED will flash red until you begin

the charge process by pressing the

Start button.

2. Push the Start button to begin the

1.5-amp fast charge process. The

charger will beep and the LED will

remain solid in color.

Once the battery has peaked, the beeper

will repeatedly sound and the LED will

once again flash. When this occurs, the

charger is in trickle charge mode.

INSTRUCTIONS

Pit Peak Features

Supplying Power to the Charger

Charging 4/5 Cell Ni-Cd or Ni-MH

Receiver Packs

PIT PEAK

™

4/5 Cell Ni-Cd and Ni-MH

Receiver Pack Charger

Summary of content (2 pages)

PAGE 1
Supplying Power to the Charger PIT PEAK ™ 4/5 Cell Ni-Cd and Ni-MH Receiver Pack Charger INSTRUCTIONS Thank for you purchasing the Pit Peak DC Peak charger. This charger will safely charge virtually all 4/5 cell Ni-Cd and Ni-MH receiver packs. It continuously monitors the battery’s charge curve and calculates when the peak will occur (100% charge), then stops fast charging at that point. This feature helps to protect Ni-Cd and especially Ni-MH cells, which are very sensitive to heat.
PAGE 2
Re-Peak You can re-peak your battery pack by simply pushing the Start button with the battery still attached to the charger. Do not re-peak more than once per charge cycle. After the battery has re-peaked, the charger will once again transition to trickle charge. Charge Times The following are estimated charge times needed for the Pit Peak to charge a fully discharged battery pack. However, since most battery packs are not fully discharged prior to charging, actual charge times may vary.