User Manual

17
PC CONNECTION
NI-CD SENSITIVITY D. PEAK – DEFAULT
The D.Peak (Delta Peak) value is adjustable between 3mV/Cell and 15mV/
Cell. 10mV/Cell is a good starting point for Ni-Cd batteries. If the Delta Peak
value is too high, you risk overcharging the battery; if the value is too low,
charging will stop before the battery reaches full capacity.
KEY BEEP (DEFAULT ON) / VOICE (DEFAULT ON)
Use the Key Beep/Buzzer menu to set the key beep and charger voice
announcements ON or OFF as needed. We recommend that you leave the
alarm ON to alert you when charging is complete or if there is cause for
alarm during charging.
DC INPUT LOW
Defi nes the minimum voltage the charger will operate at when using a DC
power supply.
LOAD FACTORY SETTINGS PRESS ENTER > 2S
Press the ENTER / Start button for more than 2 seconds to reset all charger
values to the default values.
TRICKLE CHARGE SETTINGS
When turned on, this selection controls if the charger will trickle charge Trickle
charge. This setting lets the charger provide a small current after a charge has
fi nished to counter the effects of self-discharge, helping to keep the battery
fully charged long as the batteries are left connected to the charger. Trickle
charging current is only available when charging NiMH/NiCd batteries.
HARDWARE AND FIRMWARE SETTINGS
This selection will scroll automatically through 3 pages;
Page 1 will display the Hardware and Firmware version numbers.
Page 2 will display the Bluetooth MAC number.
Page 3 will display the password to connect to a bluetooth device.
NiCd Sensitivity
D.Peak 4mV
Key Beep ON
Voice ON
Load Factory Set
Enter
VERSION
HW: FW:
Trickle ON/OFF
OFF
DC INPUT LOW
10.0V
The free Charge Master software provides additional functionality and
graphing capabilities when used with the charger.
Use the software to initiate and control charging, monitor pack voltage, cell
voltage and other data during the charge process, and display real-time graphs.
In order to connect the charger to the computer and use the Charge Master
software, a “USB Micro B to Type A” USB cable is required (not included) to
connect the USB Micro B data port on the charger to your PC.
You can control, monitor, and operate both charger channels from one computer.
The Charge Master software can be download from www.horizonhobby.com