User Manual

14 www.DynamiteRC.com
Dynamite Ultra AC/DC Charger/Cycler
Dynamite Ultra AC/DC Charger/Cycler
www.DynamiteRC.com 15
Pb Charge Mode
Pb Charge
4.0A 12.0V
Suggested charge rate for PB charging is 0.3C
(i.e. .3 x 5Ah=1.5A).
Message during Pb Charging
Pb 000:01 0001
Chg 0.58A 14.21V
See the status by turning dial during the charge
process.
Select Voltage
14.7V
1. Selected Fast Charge Cutoff Voltage.
The cutoff value is predetermined when
selecting the 2V, 6V, or 12V setting before
charging and is not adjustable once charging has
begun.
Input 13.01V
System Temp 36°C
2. Input Voltage/System Temperature
Safety Timer
ON 720min
3. Max Charge Time
Capacity Cut Off
ON 9900 mAh
4. Max Charge Capacity
Pb Discharge Mode
Pb Discharge
1.0A 10.8V
Corresponding discharge voltage for Pb
battery packs:
1.8V (2V), 5.4V (6.0V), 10.8V (12V).
Message during Pb Discharging
Pb 000:01 0001
DIS 1.00A 11.96V
See the status by turning the dial during the
charging process.
Select Voltage
10.8V
1. Selected Discharge Voltage Cutoff
The discharge cutoff voltage value is
predetermined when selecting 1.8V, 5.4V, or
10.8V setting for the corresponding 2V, 6V,
or 12V battery being discharged and is not
selectable during discharge.
Input 13.01V
System Temp 36°C
2. Input Voltage/System Temperature
Warning Information
1. If the battery connection is lost during
operation, the OPEN/STOP error will ash.
Reconnect battery or replace.
2. Low Input Volt: Power input is below
minimum requirements. Increase source
power voltage.
3. Reverse Polarity: Battery polarity reversed
4. WaitingOverheating:Chargertemperature
overheated. Lower charge/discharge
current rates and be sure the cooling fan is
unobstructed.
5. After discharging, Ni-MH/END will ash
alternately.
6. Whenthechargereachesthenegativedelta
voltage, the Ni-MH/FULL is displayed.
7. WhenthechargereachestheTimedsetting
limit, the Ni-MH/TIME is displayed.
8. Whenthechargereachesthecapacity
setting limit, the Ni-MH/CAPA is displayed,
Ni-MH/CAPA will ash alternately.
9. WhenthechargereachestheTemperature
setting limit, the Ni-MH/TEMP is displayed.
10. Li-Po/Li-FeBatteryLowVoltage,LOW/VOL
will ash alternately.
11. Cooling fan is not working, FAN/STOP will
ash alternately.
System Err
Return to Repair
12. Charger Breakdown
Current Err
Return to Repair
13. Charger Breakdown
Safety Precautions
Failure to exercise caution while using this
product and comply with the following warnings
could result in product malfunction, electrical
issues, excessive heat, FIRE, and ultimately injury
and property damage.
• Readallsafetyprecautionsandliteratureprior
to use of this product.
• Neverleavethebatteryandcharger
unattended during use.
• Neverattempttodismantlethecharger.
• NeverattachyourchargertobothanACand
DC power source at the same time.
• Neverconnectthechargertoanautomobile
12V battery while the vehicle is running.
• Neverreversethepositiveandnegative
terminals.Wrongconnectionwilldamagethe
battery and may cause damage to the charger.
• Neverallowminorstochargebatterypacks
without adult supervision.
• Neverdropchargerorbatteries.
• Neverattempttochargedeadordamaged
batteries
• Neverattempttochargeabatterypack
containing different types of batteries.
• Neverchargeabatteryifthecablehasbeen
pinched or shorted.
• Neverallowbatteriesorbatterypacksto
come into contact with moisture at any time.
• Neverchargebatteriesinextremelyhotor
cold places (recommended between 50-80
degrees F) or place in direct sunlight.
• Neverconnecttheinputjack(DCinput)to
AC power
• Alwaysuseonlyrechargeablebatteries.This
charger cannot charge batteries such as “heavy
duty,” “Alkaline battery,” “Nickel”, or “Mercury
battery.”
• Alwaysconnectthepositiveredlead(+)and
negative black lead (-) terminals of the battery
to the charger terminals correctly.
• Alwaysdisconnectthebatteryaftercharging,
and let the charger cool between charges.
• Alwaysinspectthebatterybeforecharging.
• Alwaysterminateallprocessesandcontact
Horizon Hobby if the product malfunctions.