User Manual
10 www.DynamiteRC.com
Dynamite Ultra AC/DC Charger/Cycler
Dynamite Ultra AC/DC Charger/Cycler
www.DynamiteRC.com 11
complete.
E. D/1 alternate ashing designates that the
charger is in the cool down time period after
discharging.
F. C/1 alternate ashing designates that the
charger is in the cool down time period after
charging.
Charge and discharge capacities in mAh will be
displayed after the cycle is complete.
WARNING: If at any time during the
charge process the battery pack(s) become hot
or begin to puff unplug the battery immediately
and discontinue the charge process as batteries
can cause re, collateral damage and injuries.
Li-Ion, Li-Po and Li-Fe
Charge Mode
WARNING: Li-Po batteries can cause
serious injury and re if charged inappropriately.
Always conrm the battery voltage and series
cell count is correct and never charge higher
than a 1C rate. (1C = charger current equals
the battery capacity. Example: A 1000mAh
battery’s charge current limit is 1 amp. Example B
3300mAh battery’s charge current is 3.3A)
Li-Poly Charge
4.0A 14.8V(4S)
Message during Li-Ion/Poly Charging
Is 14.8V(4S) ?
No=Stop/Yes=Ente
Confirm if the number of selected battery cell
is correct. To select the correct voltage, use the
following formula to calculate the voltage of
yourpack:3.7V/cell(e.g.4S=4*3.7=14.8V).Be
careful to confirm the correct voltage and cell
count. Failure to due so may result in damage
or fire.
Select Voltage
16.8V (4S)
1. Selected Charge Voltage
Input 13.01V
System Temp 36°C
2. Input Voltage/System Temperature
Safety Timer
ON 720min
3. Max Charge Time
Capacity Cut Off
ON 9900 mAh
4. Max Charge Capacity
4.12 4.13 4.11
4.12 0.00 0.00
5. Battery Voltage Per Cell
High 4.131V (S2)
Low 4.119V (S3)
6. This screen shows which battery has the
High/Low Voltage
NOTE: The second battery has the maximum
voltage. The third battery has the minimum
voltage.
Unbalanced Volt
12mV
7. Unbalanced Voltage
The voltage difference between the high voltage
and low voltage cells in the battery pack.
Message after Li-Ion/Poly Charging
4.12 4.13 4.11
4.12 0.00 0.00
1. Battery Voltage Per Cell
High 4.131V (S2)
Low 4.119V (S3)
2. WhichBatteryhastheHigh/LowVoltage
The second battery has the High voltage.
The third battery has the Low voltage.
Unbalanced Volt
12mV
3. Unbalanced Voltage
The voltage difference between the high voltage
and low voltage cells in the pack.