User Manual

8 www.DynamiteRC.com
Dynamite Ultra AC/DC Charger/Cycler
Dynamite Ultra AC/DC Charger/Cycler
www.DynamiteRC.com 9
Peak Voltage
9.07V
2. Battery Pack Peak Voltage
Input 13.01V
System Temp 36°C
3. Input Voltage/System Temperature
Bat Temp
29°C
4. Battery Temperature
Batt Temp Cutoff
ON 50°C
5. Max Charge Temperature
Safety Timer
ON 720min
6. Max Charge Time
Capacity Cut Off
ON 9900 mAh
7. Max Charge Capacity
Cycle Charge
Delay 1min
8. Charge/Discharge Delay Time
Message after Ni-MH Charging
END 058 : 08 : 3188
Chg 0.01A 8.08V
See the status by turning switch to left/right.
Peak Voltage
9.07V
1. Battery Peak Voltage
Bat Temp
29°C
2. Battery Temperature
Ni-MH Discharge Mode
NiMH Discharge
1.0A 6.0V
Notes Regarding Discharging
Discharging/cycling Ni-MH and Ni-Cd packs
can increase capacity and rejuvenate neglected
batteries. Discharge capacity and average pack
voltage will allow you to compare batteries to
choose the pack with the best performance to
maximize run time and power.
Press the mode button once Ni-MH is selected
and rotate the dial until the Discharging screen
appears. Press the dial to select discharge current
rate and cutoff voltage.
Message during Ni-MH Discharging
Press and hold the START button for 3 seconds
to begin discharging.
NOTE: Discharge voltage rates are per pack,
not per cell. Do not choose a discharge cutoff
voltage below .8V/cell or damage to the battery
may occur.
NiMH 000 : 01 : 0001
DIS 0.10A 7.62V
See the status by turning switch to left/right.
Input 13.01V
System Temp 36°C
1. Input Voltage/System Temperature
Bat Temp
29°C
2. Battery Temperature
Batt Temp Cutoff
ON 50°C
3. Max Discharge Temperature
Ni-MH Discharge/Charge
Cycle Mode
NiMH Dhg>Chg 01
1.0A/6.0V ->4.0A
The screen above is displayed when the charger
is set to charge after the discharge period.
NiMH Chg>Dhg 01
4.0A->1.0A/6.0V
The above screen is displayed when the charger
is set to discharge after charging.
Message during Ni-MH Discharging/
Charging Cycle
NiMH 000 : 01 : 0001
D>C 0.10A 7.62V
The screen above shows discharge then charge
status.
NiMH 000 : 01 : 0001
C>D 0.10A 7.84V
This screen is displayed during the charge then
discharge mode.
A. D>C means that the charger will discharge
rst, then charge.
B. C>D means the charger will charge rst,
then discharge.
C. D/1 ashing means the charger is in the
discharge process and will charge when the
discharge mode is complete.
D. C/1 ashing means the charger is in the
charging process and will discharge when