User Manual

DYN4928 Li-Po Tazer ESC Set Up Addendum:
Please use the following updated set up procedure for your DYN4928
Li-Po Tazer ESC
Speed Control Programming
Note: While in programming mode, no power is applied to the motor.
Battery Selection: When the ESC is powered on, the LED will be flashing for 2
seconds to indicate the Selected Battery Type.
During this time the user can press the key to toggle between LiPo and NiMH/NiCd
modes. After the key has been pressed (battery type selected), the LED will flash for
2 more seconds.
A. Turn on ESC and push button once within 2 seconds, push again to toggle
between modes.
B. Red light indicates LiPo mode (with 6 volt cut-off)
C. Green light indicates NiMH/NiCd mode
One Touch Endpoint Setup
Note: Please be sure to set all throttle trim settings to neutral before performing an
endpoint setup.
A. Hold button and turn on ESC. Once the Red/Green light comes on, release
button.
B. Pull trigger to the full throttle position until the green light goes from
flashing to solid green and then begins to flash red. Your forward endpoint is
now set.
C. Push the trigger to the full reverse position until the flashing red light turns
solid. At this point your reverse/brake endpoint is set.
D. Return the trigger to the neutral position. The green light will now be solid
and you are ready to go.
Selecting Speed Control Modes
To change modes on your LiPo Tazer 10T ESC, hold the setup key for over 5
seconds while in the neutral position. Once you reach the desired mode, simply
release the key and you are ready to go.
Forward/Reverse mode – Solid Green LED
Forward Only mode – Fast Flashing Green LED
Practice mode – Slow Flashing Green LED
Crawler mode* - Solid Green and Red LED
*Note: Crawler mode is for use in rock crawling vehicles only. Do not use this
mode with other vehicles. Doing so may damage the vehicle.