User Manual

EN
9
Using the Quick Programming Card allows you
to go directly into the mode setting that you wish
to change without waiting through any of the
functions that precede it.
1. RemovetheESCreceiverleadfromthe
receiver and connect it to the programming
card. Be sure to observe correct polarity.
2. ConnectabatterytotheESC.
3. TurnontheESC.Youwillhear6beeps
followed by one rising tone. You have now
entered into programming mode.
4. Usingtheblackbuttonsonthefrontofthe
card, enter the function number (listed on
thefrontofthecard)followedbytheoption
number(listedonthebackofthecard)that
you wish to choose. For example, if you wish
toadjustthebrakestrengthto80%anddrag
braketo10%:pressbutton#1followedby
button#6.Afterabout1secondyouwillhear
1longtonefollowedby6beepsconrming
the programming setting. Next, you will hear
1risingtonewhichallowsyoutoenterthe
nextsetting.Pressbutton#2followedby
button#3.Afterabout1secondyouwillhear
2longtonesfollowedby3beepsconrming
the programming setting. Once again, you
willhear1risingtone.Youcaneitherenter
into another function for modification or
simplyturnoffthepowertotheESCtoend
programming.
5. DisconnecttheESCreceiverleadfromthe
programming card.
6. ConnecttheESCreceiverleadtothereceiver.
Troubleshooting Guide
Symptom Solution
Steeringservooperatesbutthe
motor does not run
Programming is not complete.
ReprogramtheESCbyfollowingtheprogramminginstructions.
Speedcontrolisconnectedtoreceiverincorrectly.
Refer to manufacturer’s instructions.
Motordefective.Testmotorindependently,repairor
replace as needed.
Lowbatteries.Chargeasneeded.
Overload Protection enabled.
Check motor and connections.
Steeringandmotordonot
function
Receiver wired incorrectly. Check polarity and orientation of control
plugs.
Radioinoperational.Seeradioinstructionmanual.
Batteries discharged. Recharge or replace.