User Manual

ManualsBrandsDynamite ManualsHobbyDynamite DC Vision Peak Ultra

DC Peak Charger For 1- to 8-Cell Ni-Cd, Ni-MH and 1- to 3-Cell

Lithium Polymer Battery Packs

INSTRUCTION MANUAL

4105 Fieldstone Road

Champaign, IL 61822

USA

Dynamite

products are distributed exclusively by Horizon Hobby, Inc.

www.dynamiterc.com

Revised 12/09 7095.2

DC Vision Peak

™

Ultra

• Vision LCD icon shows charge status

• Multi-function LCD shows charge time, charge current

and voltage

• Charges virtually all 1- to 8-cell Ni-MH & Ni-Cd packs

and 1- to 3-cell Li-Po packs

• Adjustable charge rates from 0.1A–5A (Ni-MH & Ni-Cd)

• Adjustable charge rates from 0.1A–3A (Li-Po)

• Input and output circuit protection

• Automatic trickle charge

Summary of content (6 pages)

PAGE 1
DC Vision Peak™ Ultra DC Peak Charger For 1- to 8-Cell Ni-Cd, Ni-MH and 1- to 3-Cell Lithium Polymer Battery Packs INSTRUCTION MANUAL • Vision LCD icon shows charge status • Multi-function LCD shows charge time, charge current and voltage • Charges virtually all 1- to 8-cell Ni-MH & Ni-Cd packs and 1- to 3-cell Li-Po packs ©2010 Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, IL 61822 USA • Adjustable charge rates from 0.1A–5A (Ni-MH & Ni-Cd) • Adjustable charge rates from 0.
PAGE 2
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com/ProdInfo/Files/dyn4033-manual.pdf.
PAGE 3
Features NOTICE: A lways connect the positive red lead (+) and negative black lead (-) terminals of the battery to the charger terminals correctly. Never reverse the positive and negative terminals. Wrong connection will damage the battery and may cause damage to the charger. 3 7 Setting the Charge Perimeters 4 8 When power is supplied to the charger, the charger will beep and the cooling fan will begin to run. The display will default to the “Voltage” indicator.
PAGE 4
Adjusting Charge Current During the Fast Charge Period Once the fast charge period has begun, the charge current is locked in. To change the charge current: • Press the Start/Select button and the LED will begin to flash. • Press the Display Mode Switch until the amps are displayed on the LCD. Charge Timer The Charge Timer records the fast charge time in minutes (figure 11). To determine the charge capacity applied to the battery, multiply the charge time in hours by the charge current in amps.
PAGE 5
has no control over use, setup, final assembly, modification or misuse, no liability shall be assumed nor accepted for any resulting damage or injury. By the act of use, setup or assembly, the user accepts all resulting liability. If you as the Purchaser or user are not prepared to accept the liability associated with the use of this Product, you are advised to return this Product immediately in new and unused condition to the place of purchase.
PAGE 6
10 11