User's Manual

must be maintained between the user's body and the back of the phone, including the antenna. Third-party

belt-clips, holsters and similar accessories containing metallic components shall not be used. Body-worn

accessories

that cannot maintain 5mm/10mm separation distance between the user’s body and the back of the phone,

and have not been tested for typical body-worn operations may not comply with FCC RF exposure limits

and should be avoided.

For more information about RF exposure, please visit the FCC website at www.fcc.gov

Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it

receives and also sends out radio frequency (RF) signals. In August, 1996, the Federal Communications

Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones.

Those guidelines are consistent with the safety standards previously set by both U.S. and international

standards bodies:

<ANSIC95.1> (1992) / <NCRP Report 86> (1986) / <ICIMIRP> (1996)

Those standards were based on comprehensive and periodic evaluations of the relevant scientific

literature. For example, over 120 scientists, engineers, and physicians from universities, government

health agencies, and industry reviewed the available body of research to develop the ANSI Standard

(C95.1). Nevertheless, we recommend that you use a hands-free kit with your phone (such as an earpiece

or headset) to avoid potential exposure to RF energy. The design of your phone complies with the FCC

guidelines (and those standards).

Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or

attachments could damage the phone and may violate FCC regulations.

NORMAL POSITION:

Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder.

RF Exposure Information:

This product is compliance to FCC RF Exposure requirements and refer to FCC website search for FCC

ID: C89PRIME5-5 to gain further information include SAR Values.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user’s authority to operate the