Owner`s manual

5. Heating times do vary. Generally, it will take approximately twenty to thirty minutes to preheat the

sauna to 50 degrees Celsius / 122 degrees Fahrenheit. When the ambient temperature is low, heating

requires additional time. For the first few times of use, you may use 46 degrees Celsius /

115 degrees Fahrenheit as a reference starting point for a time period of about 15 minutes (this

represents the actual time you are in the sauna at the desired temperature). As you become more

comfortable and familiar with the sauna, you can increase the temperature and time period according to

personal preference.

6. When the temperature is at the set-up value, the digital control will maintain the set temperature.

The WORK light will remain on and the HEAT light will turn off. The emitters will stop generating

heat. Once the inside temperature drops approximately 4 degrees, the HEAT light will turn back on

and heat will again be generated by the emitters. With the digital control, the inside temperature will

always remain around the set-up value.

7. Reading lamps and/or roof lamps and/or color therapy lamps are operated by pressing the

respective buttons located towards the center of the control panel. These lamps are offered on

some models and are not available on all models.

8. Chromotherapy/Color Therapy Lighting (optional) can be operated as follows. First, you will

need to install the battery. Once the battery has been inserted into the remote, you are ready to

operate the chromotherapy/color therapy lighting system. Press the READING LIGHT button on the

sauna control panel. The white light will come on. While pointing the remote at the ceiling light, you

can press any of the colors on the remote and that color will be displayed. You can use the SHADE

button on the remote to go through a sequence of colors. If you want to turn the light off during your

sauna session, you can press the POWER button on the remote. Please note: You must be

inside the sauna room for the remote to work.

9. To operate the radio, press the power button to turn on the CD/RADIO player. Press the band to

choose between the FM/AM frequency on the radio. You must place the radio antenna above the roof

cover to receive a radio station signal. To use the CD function, insert the CD disk into the top (into the

CD slot) of the radio. If the CD player does not work, make sure the set screws on the top of the

CD/RADIO player have been removed. For more detailed instructions, please see the CD/radio

owner’s manual.

Meijer.com