Troubleshooting guide

D. Understanding The Difference Between The Inside And Outside Of The Rear Panel

You will find the heat emitters on the inside of the rear panels and buckles on the outside.

Assembly Instructions

A. Choose a good location to install the sauna

1. The location must be dry, leveled, and away from any source of water

2. MAIN POWER cord must be easily accessible

3. Two adults are required for installation

4. Wood cabin installation order: Floor Panel  Front Panel  Right Side Panel  Left Side

Panel  Rear Panel  Bench Emitter Panel  Bench  Roof Panel  Roof Cover

5. Tools Required: Philips Screwdriver and Ladder

B. Installing the FLOOR PANEL

1. Place the FLOOR PANEL on the floor. Some models have wood braces that must be installed

on the underside of the FLOOR PANEL. Please check to see if such wood braces were

packed in the box containing the FLOOR PANEL. If so, mount according to the designated

labels located on the underside of the FLOOR PANEL. Once installed, turn the FLOOR

PANEL right side up. Make sure the front side of the FLOOR PANEL is facing the correct

direction. The notches on the floor will be closer to the rear of the sauna than the front of the

sauna. (see Panel Descriptions)

C. Installing the FRONT PANEL and SIDE PANELS

1. Place the FRONT PANEL onto the recessed area on the FLOOR PANEL. Align the floor

guides with the FRONT PANEL. Do the same for the RIGHT SIDE PANEL. Buckle the

RIGHT SIDE PANEL to the FRONT PANEL. Do the same with the LEFT SIDE PANEL. (see

figure 8)

Figure 8