Owner's Manual

G. Installing the FRONT PANEL

1. Place the FRONT PANEL onto the recessed area on the FLOOR PANEL. Align guides on the

LEFT SIDE PANEL with the guide inserts on the FRONT PANEL. The LEFT SIDE PANEL will

need to be lifted in order to lock the guide inserts on the LEFT SIDE PANEL into the guides on

the FRONT PANEL. Secure in place by pulling down on the FRONT PANEL. Make sure all

the guides are locked in place and the top of the LEFT SIDE PANEL is even with the FRONT

PANEL. Do the same with the RIGHT SIDE PANEL. (see Figure 18)

Please Note: You may need

to undo the buckles on the

REAR WALL PANEL in order

to lift the SIDE PANELS up

and onto the FRONT PANEL.

Figure 18

H. Installing the ROOF PANEL

1. The side with the power supply box faces upward.

2. The edge nearest the power supply is the front of the ROOF PANEL. Be careful of the wires

coming from the SIDE and REAR PANELS when you set the ROOF PANEL down onto the

panels. Feed the wires through the holes in the ROOF PANEL. Feed the control cable and

CD connectors down from the ROOF PANEL through the long-shaped hole to the inside of the

sauna (for CD/radio hookup). (see Figure 19 and Figure 20)

3. Be careful not to force the ROOF PANEL into place. Make sure that the wires are properly fed

through the holes.

4. When all the wires are fed through their appropriate holes, lower the ROOF PANEL into place.

Figure 19 Figure 20