Owner's Manual
12
Figure 14
F. Installing the BENCH EMITTER PANEL, BENCH PANEL and BENCHES
1. Locate the (2) square wood frames that have two cutouts on one side and a vertical slot on the
other side. Place one of the wood frames next to the glass window with the two cutouts facing
the glass window and the vertical slot facing towards the front. The cutouts fit along the glass
window moldings. The wood frames are not interchangeable and so make sure you have
them next to the correct glass window. Do the same with the second wood frame next to the
other glass window.
2. Slide down the BENCH EMITTER PANEL by lining up its sides with the vertical guides on the
side panel and wood frame. The emitter grid will face outward (toward the front of the sauna)
and the cord will be at the bottom of the emitter grid on the inside (between the BENCH
EMITTER PANEL and the REAR PANEL). Push the BENCH EMITTER PANEL all the way
down until it is touching the FLOOR PANEL and is secured in place. Do the same with the
shorter bench panel. (see Figure 15)
3. Plug in the BENCH EMITTER connector to the corresponding inlet located on the REAR
PANEL. Also plug the floor emitter connector to the corresponding inlet on the other REAR
PANEL. (see Figure 16)
4. Install the BENCHES by sliding them over the horizontal bench guides on the side panels.
Push the BENCHES all the way in until they touch the REAR PANELS and are secured in
place. Make sure to install the BENCHES with the smooth and finished sides facing up. (see
Figure 17)
Figure 15 Figure 16 Figure 17