Manualshelf

Owner's Manual

ManualsBrandsDynamic Sauna ManualsHome FurnishingVersailles HF Edition DYN-6202-03 75" Far Infrared Sauna with 2 Person Capacity, 6 Carbon Heating Elements, MP3 Auxiliary Socket and Interior Reading Light
11121314151617181920
12
E. Installing the BENCH EMITTER PANEL and BENCH
1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide
the BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.
(see Figure 12)
2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the REAR
WALL or SIDE WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL connector to
the corresponding inlet on the REAR WALL or SIDE WALL PANEL.
3. Install the BENCH at an angle as also seen in Figure 12. Then slide it over the horizontal
bench guides on the side panels. Slide the BENCH all the way in and against the REAR WALL
PANEL. Make sure to install the BENCH with the smooth and finished side facing upward. If
screws were provided, use them to screw down the bench.
Figure 12
F. Installing the ROOF PANEL
1. The side of the ROOF PANEL with the power supply (control box) is the top of the ROOF
PANEL.
2. The edge nearest the power supply is the front of the ROOF PANEL. Be careful of the wires
coming from the SIDE and REAR PANELS when you set the ROOF PANEL down onto the
panels. Feed the wires through the holes in the ROOF PANEL. Feed the control cable and
buzzer plug up through the ROOF PANEL.
3. Be careful not to force the ROOF PANEL into place. Make sure that the wires are properly fed
through the holes. Furthermore, make sure the ROOF PANEL sits snugly into the RIGHT SIDE
WALL PANEL and RIGHT FRONT WALL PANEL. Pull down on the ROOF PANEL slightly to
make sure it is secured in place. (see Figure 13)