User's Manual

Page | 17
4.2 NETWORK SETTINGS
Accessed from the Main Menu, the Network Settings allows the user to change the
network the TW-3.0 will operate on (1 – 75) and also switch the TW-3.0 between
Master and Slave operation.
Only one master TW-3.0 should be used on a network at a time, multiple masters on
the same network will cause interference.
If a second display is required, set this to a Slave on the same network.
If a second TW-3.0 connected to another remote unit is required within the same signal
range, it should be connected on a different network ID. To do this, change the
network ID and repeat the pairing process detailed in section 2.1.