Integration Manual

2.0 CONNECTIONS
2.1 LOAD CELL CONNECTION
The load cell can be wired as either a 4-wire or 6-wire strain bridge.
1) 6-wire connection – Connect as the picture above. Connections to A and B are
not made. Shield is optional.
2) 4-wire connection – Use Signal + and signal -, Sense + and Sense -. Make a link
between Excitation + and A, and Excitation - and B. Shield is optional.
2.2 LED CONNECTION
Connect the LED anode to LED+ and the LED cathode to LED –
The LED should be 2VDC with an internal resistor.