Owner Manual

J. Putting on the ROOF COVER

1. Place the ROOF COVER over the top of the sauna. Be cautious when pulling the power cord

through the hole in the roof cover. Gently place the ROOF COVER onto the ROOF PANEL.

When the edges are aligned, screw the ROOF COVER to the roof panel. (see Figure 23)

Figure 23

Operating the Sauna

NOTE: Before the sauna is turned on, remove plastic protective covering from the

CONTROL PANELS. Please check and confirm that the connections to the POWER

SUPPLY, HEAT EMITTERS, CD/RADIO, and TEMPERATURE SENSOR are connected

properly. The power supply voltage and frequency must match the requested voltage

and frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC 20AMP

Dedicated Circuit).

Since many materials absorb the infrared rays, minimal clothing is recommended for

maximum effect. The infrared sauna emitters are designed to heat you and not

necessarily the air inside the sauna. It is not a hot box like a traditional sauna. The

temperature gauge is a guide for your safety. It is recommended that you drink water

before, during, and after sauna use to prevent dehydration since body fluids will be lost

through perspiration. It is not recommended to shower after use since the pores in your

skin will be open and could possibly absorb anything in the water.