Owner Manual

E. Installing the BENCH HEAT EMITTER PANEL and BENCH

1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the

BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.

(see Figure 12)

2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the right

side of the REAR WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL connector

to the corresponding inlet on the left side of the REAR WALL PANEL. On model DYN-6310-

02, you will connect the floor heater with the cord from the LEFT SIDE WALL PANEL labeled

HT3.

3. Install the BENCH at an angle as seen in Figure 12. Then slide it over the horizontal bench

guides on the side panels. Slide the BENCH all the way in and against the REAR WALL

PANEL. Make sure to install the BENCH with the smooth and finished side facing upward. It

is optional to screw the BENCH down to the REAR WALL PANEL.

Figure 12

F. Installing the FRONT GLASS DOOR HANDLE

1. Now that the FRONT WALL PANEL has already been installed, the inner and outer door

handles need to be mounted to the FRONT GLASS DOOR. According to Figure 13 and

Figure 14, the FRONT GLASS DOOR must sit between the (2) white washers. The screws

are inserted from the inside of the FRONT GLASS DOOR and screwed into the outer

handle. BE SURE NOT TO OVER TIGHTEN THE SCREWS OR YOU WILL SHATTER THE

FRONT GLASS DOOR. Next, the inner door handle needs to be inserted over the screws.

Used the provided Hex Wrench to tighten the (4) hex screws. (see Figure 15)