Owner Manual

PLEASE NOTE: If your sauna has the optional LED Accent Lighting above the REAR WALL HEAT

EMITTER PANELS and below the BENCH, you will need to connect the connector from the black/white

wires coming from the BENCH (located underneath the bench) to the black/white wire connector at the

REAR WALL PANEL.

F. Installing the FRONT GLASS DOOR HANDLE

1. Now that the FRONT WALL PANEL has already been installed, the inner and outer door

handles need to be mounted to the FRONT GLASS DOOR. According to Figure 13 and

Figure 14, the FRONT GLASS DOOR must sit between the (2) white washers. The screws

are inserted from the inside of the FRONT GLASS DOOR and screwed into the outer

handle. BE SURE NOT TO OVER TIGHTEN THE SCREWS OR YOU WILL SHATTER THE

FRONT GLASS DOOR. Next, the inner door handle needs to be inserted over the screws.

Used the provided Hex Wrench to tighten the (4) hex screws. (see Figure 15)

Figure 14

Figure 15

Figure 13

H. Connecting the plugs on the ROOF PANEL

(POWER SUPPLY 1)

1. Connect the plugs according to their respective labels. (see Figure 16)

2. Connect the CTRL plug from the power supply box to the CTRL plug from the control panel.

Then screw together. (see Figure 17)

3. Connect the buzzer connection. (see Figure 17a)(not available on models with Bluetooth)

PLEASE NOTE: If your sauna has the optional LED Accent Lighting above the REAR WALL HEAT

EMITTER PANELS and below the BENCH, you will need to connect the connectors from the black/white

wires coming up the REAR WALL PANEL to the black/white wire connectors up on the ROOF PANEL.