Owner Manual

Figure 11

E. Installing the BENCH HEAT EMITTER PANEL and BENCH

1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the

BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.

(see Figure 12)

2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the right

side of the REAR WALL PANEL for sauna model DYN-6220-01 and to the corresponding inlet

located on the RIGHT SIDE WALL PANEL for sauna models DYN-6306-01/DYN-6330-

01/DYN-6440-01. Also plug the FLOOR HEAT EMITTER PANEL into the left side of the

REAR WALL PANEL for sauna model DYN-6220-01 and into the LEFT SIDE WALL PANEL

on sauna models DYN-6306-01/DYN-6330-01/DYN-6440-01.

3. Install the BENCH at an angle as seen in Figure 12. Then slide it over the horizontal bench

guides on the side panels. If your model comes with the optional LED accent lighting on the

underside of the BENCH, you will need to connect the harness (black and white wires) coming

from the right side of the REAR WALL PANEL to the connection on the underside of the

BENCH. Next, slide the BENCH all the way in and against the REAR WALL PANEL. Make

sure to install the BENCH with the smooth and finished side facing upward. It is optional to

screw the BENCH down to the REAR WALL PANEL.

Figure 12