Specifications

HARDWARE INSTALLATION
PP 41x/03x 2-9
2.7.1 Hard Disk Storage Kit (AD CP1/DR1)
The option kit comprises:
• A 2.5 inch EIDE disk drive
• A ribbon cable assembly
• Four M3 x 10mm screws
• Four M3 x 5mm spacers
The ribbon cable assembly has a 50-way connector at one end and a 44-way connector at the
other end. The 50-way connector plugs into the disk drive and the 44-way plugs into P5 on the
PP 41x/03x.
1) Plug the 50-way connector into the disk drive as shown in Figure 2-7 below, note the
orientation.
50-way Connector
44-way Connector
Pin 1
P5
Stripe
Figure 2-7 Disk Drive Cable Installation
2) Plug the 44-way connector into P5, note the orientation.
3) Fix the disk drive into position using the four screws and spacers provided. Do not over
tighten the screws.
NOTE: If the board is likely to be subjected to mechanical vibration a suitable thread lock
compound applied to the screws should be considered.