Specifications

INTRODUCTION
PP 41x/03x 1-7
1.4 Additional Board Options
The PP 41x/03x board may be ordered with one of a few factory fitted configuration options, in
particular the Ethernet (on J3 connector):
• Configured for PICMG 2.16 backplane networking
• Configured for rear panel Ethernet via connectors (on RTM)
Two mezzanine mass storage options are available, namely:
• A 2.5 inch EIDE hard disk drive of at least 20 Gbyte capacity
• A dual CompactFlash carrier that also supports the Hitachi GST MicroDrive™
Refer to the PP 41x/03x datasheet for ordering information. The datasheet also details the
SDRAM capacity options.
NOTE: The mezzanine mass storage options use the PMC site 1 area. No PMC module
may be fitted in this site when a mezzanine mass storage option is fitted. PMC site 2 is
not affected by fitting a mezzanine mass storage option.
A bottom side cover is available. This protects the components on the bottom side of the board
from accidental damage or short circuits, particularly during hot-swap insertion and removal.