User`s manual

Universal Video Input Unit Option
Dynamic Display’s unique Universal Video Input Option was designed to accept a wide variety of non-standard legacy
video timing formats. It converts the signal to a VGA-style video format that is acceptable to most modern LCD
displays. The Universal Video unit has a unique sync discriminator circuit that will filter out extraneous sync pulses
found in some legacy video signals. The phase lock loop design supplies sync pulses that are missing in other legacy
video formats.
With the Universal Video Input Option, the user has the choice of switching between two separate video input ports.
The first video input port is a standard HD-15 D-sub connection with fixed 75 ohm termination. The second video port
has five BNC connections; Red, Green, Blue Video, Vertical Sync, and Horizontal/Composite Sync. The input
impedance of each BNC inputs may be switched between 75 Ohms and Hi impedance for video loop-through
applications.
Either of these two video ports can accept the following video signal format types:
• Three-wire RS170 and RS343-style analog composite sync-on-green video formats - with and without serrations
and equalizing pulses.
• Four-wire analog video formats with separate composite sync.
• Five-wire Red, Green, Blue Video, with separate horizontal and vertical syncs.
In addition to these analog video timings, the Universal Video Input Option also accepts TTL video signals on Port one
via a 9-pin D-sub connector for CGA and EGA monitors.
Connecting The Universal Video (UVI) Box
Follow the instructions below to install the Universal Video Box to your Flat/Panel monitor.
Required tools: #2 Phillips Screw Driver
1.
Mounting The UVI Box:
• Power down the Flat Panel Monitor and unplug the Power Adapter Cable (A/C - D/C Power Supply) going to
the Flat Panel monitor unit.
• Unplug the Video Input Cable (SUB-D, 15HD) from your system going to the Flat Panel monitor unit.
• Mounting the (UVI) Box hardware is determined by which Flat/ Panel monitor you have. The following list is
for Dynamic Displays Flat Panel systems:
a.
15” Flat Panel Plastic Enclosure
8115061: Screw, Metric, Pan Head, Philips Head, Size M 4X8, Quantity of 4
8120030: Washer ,Locking, Number 8, Quantity of 4
b.
19” Flat Panel Plastic Enclosure
8115032: Screw ,Metric, Pan Head, Philips Head, Size M 3X8, Quantity of 4
8120027: Washer, Locking External, Size 4, Quantity of 4
c.
Rack Mount and Panel Mount
8114455: Screw SEM, Pan Head, Philips Head ,Size 8-32 by 0.375, Quantity of 4
• Mount the (UVI) box to the VESA 100 mounting holes located on the rear of the Flat / Panel monitor.
2.
Connect Video and Power to UVI and Flat Panel Monitor
• Plug the (VGA, SUB-D, 15HD) cable from the (UVI) box to the Flat / Panel monitor.
• Plug the Power Adapter / Cable (A/C - D/C Power Supply) into the input connector (12 VDC) on the (UVI) box.
• Plug one end of the DC Jumper Power Cable into the output connector (12 VDC) on the (UVI) box.
• Plug the other end of the DC Jumper Power Cable into the Flat/Panel (12VDC) input - located on the rear of
Flat / Panel monitor.
• Determine Video Plug input from your System:
The (UVI) box supports D-SUB or BNC:
Dynamic Displays, Inc Doc # 0015039
1625 Westgate Road Manual, QES1500 Progressive Series Rev: E
Eau Claire WI, 54703 Page 22 of 24