User`s manual

Binary (HEX) File Version Information on OSD:
In case problems arise with MCU file updates, use the following procedure to read the current version and file name of
the MCU.
1. Monitor on with signal connected and displays normally.
2. Pull power plug off (12 VDC plug)
3. Press monitor "On” button
4. plug in the power 12 VDC plug
5. Release monitor "On” button after 2 seconds.
6. Monitor displays normally
7. OSD menu will have "FT" displayed
8. Select FT, can see the HEX file name.
Burn-in Procedure
1. Remove Power from unit - Unplug 12 VDC Plug.
2. Remove any video input signal.
3. Hold down "Power Button" on the keypad
4. While power button is held down, return the power to the unit (power up).
5. Wait for the LED on the keypad to blink once, and then lift up on the "Power Button" (remove finger).
6. Monitor will cycle through several different patterns without any input video signals.
Dynamic Displays, Inc Doc # 0015039
1625 Westgate Road Manual, QES1500 Progressive Series Rev: E
Eau Claire WI, 54703 Page 12 of 24