User`s manual

Universal Video Input Unit Option
Dynamic Display’s unique Universal Video Input Option was designed to accept a wide variety of non-
standard legacy video timing formats. It converts the video input signal to a VGA-style video format that
is acceptable to most modern LCD displays. The Universal Video unit has a unique sync discriminator
circuit that filters out extraneous sync pulses found in some legacy video signals. A phase lock loop
design supplies sync pulses that are missing in other legacy video formats.
With the Universal Video Input Option, the user has the choice of switching between two separate video
input ports. The first video input port is a standard HD-15 D-sub connection with fixed 75 ohm
termination. The second video port has five BNC connections; Red, Green, Blue Video, Vertical Sync,
and Horizontal/Composite Sync. The input impedance of each BNC input may be switched between 75
Ohms and Hi impedance for video loop-through applications.
Either of these two video ports can accept the following video signal format types:
• Three-wire RS170 and RS343-style analog composite sync-on-green video formats - with and without
serrations and equalizing pulses.
• Four-wire analog video formats with separate composite sync.
• Five-wire Red, Green, Blue Video, with separate horizontal and vertical syncs.
In addition to these analog video timings, the Universal Video Input Option also accepts TTL video signals
on Port One via a 9-pin D-sub connector for CGA and EGA monitors.
Connecting The Universal Video (UVI) Box
Follow the instructions below to install the Universal Video Box to your Flat/Panel monitor.
Required tools: #2 Phillips Screw Driver
1. Mounting The UVI Box:
• Power down the Flat Panel Monitor and unplug the Power Adapter Cable (A/C - D/C Power
Supply) going to the Flat Panel monitor unit.
• Unplug the Video Input Cable (SUB-D, 15HD) from your system going to the Flat Panel monitor
unit.
• Mounting the (UVI) Box hardware is determined by which Flat/ Panel monitor you have. The
following list is for Dynamic Displays Flat Panel systems:
a. 15” Flat Panel Plastic Enclosure
8115061: Screw, Metric, Pan Head, Philips Head, Size M 4X8, Quantity of 4
8120030: Washer ,Locking, Number 8, Quantity of 4
b. 19” Flat Panel Plastic Enclosure
8115032: Screw ,Metric, Pan Head, Philips Head, Size M 3X8, Quantity of 4
8120027: Washer, Locking External, Size 4, Quantity of 4
c. Rack Mount and Panel Mount
8114455: Screw SEM, Pan Head, Philips Head ,Size 8-32 by 0.375, Quantity of 4
• Mount the (UVI) box to the VESA 100 mounting holes located on the rear of the Flat / Panel
monitor.
2. Connect Video and Power to UVI and Flat Panel Monitor
• Plug the (VGA, SUB-D, 15HD) cable from the (UVI) box to the Flat / Panel monitor.
• Plug the Power Adapter / Cable (A/C - D/C Power Supply) into the input connector (12 VDC) on
the (UVI) box.
• Plug one end of the DC Jumper Power Cable into the output connector (12 VDC) on the (UVI)
box.
• Plug the other end of the DC Jumper Power Cable into the Flat/Panel (12VDC) input - located on
the rear of Flat / Panel monitor.
____________________________________________________________________________________
Dynamic Displays, Inc Doc # 0048059
1625 Westgate Road QES1500 Progressive/Interlace Unit Rev: B
Eau Claire WI, 54703 Glee 17C2 Page 27 of 29