User`s manual

Return Flat Panel To PC Operation Once It Has Been Changed To TV Input
1. Power up the Flat Panel Monitor without Video Input.
2. TV will be displayed in the upper right hand corner of image.
3. Push the “MENU” button.
4. Push “UP” button, selecting OSD mode.
OSD
MODE
4. Push “MENU” button to (Enter).
5. Push “UP” button, selecting MEMORY RECALL.
MEMORY
RECALL
6. Push the “MENU” button.
THIS WILL RETURN YOU TO PC OPERATION.
Plug in Video input to Flat Panel Monitor.
HOW TO SET THE FLAT PANEL IN BURN-IN MODE
1. With no video signal applied to the monitor, power on the LCD. The OSD will show “no signal”.
2. On the membrane switch, push the Up key and Down key at the same time. This will change the monitor to “burn-
in” mode.
3. During “burn-in” mode if the external power is turned off and then on again the LCD monitor will stay in “burn-in”
mode.
4. To disable the “burn-in” mode: apply any signal input.
Dynamic Displays, Inc Doc # 0048058
1625 Westgate Road Manual, QES1500 Progressive/Interlace Series Rev: D
Eau Claire WI, 54703 Page 20 of 33