User`s manual

HORIZONTAL SIZE:
Press the “MENU” button then the “DOWN” button to select “H SIZE”.
Use the “UP” / “DOWN” buttons to increase or decrease the Horizontal Size. The image width will change on
the right side. Adjust to desired size. Once desired size is achieved you will have to adjust the
“HORIZONTAL POSITION” to center the image. (See PC Adjustments, step #4)
H. Size
VERTICAL SIZE:
Press the “MENU” button then the “DOWN” button to select “V SIZE”.
Use the “UP” / “DOWN” buttons to increase or decrease the Vertical Size. The image height will change on
the bottom edge. Adjust to desired size. Once desired vertical size is achieved adjust the “VERTICAL
POSITION” to center the image. (See PC Adjustments, step #4)
V. Size
HOW TO PERMANENTLY STORE USER SETTINGS TO MEMORY:
1. Power monitor up. (Use the membrane keypad “POWER” button)
2. Select the “AUTO” button. No OSD will be displayed. The monitor will recall the factory settings.
3. Select the “MENU” button. The OSD will be displayed.
4. Make adjustments and set the image to optimum viewing.
5. Select the “AUTO” button TWICE. (The OSD will disappear.) This will save your adjustments. It’s very
important that you select the “AUTO” button following your adjustments.
Dynamic Displays, Inc Doc # 0048058
1625 Westgate Road Manual, QES1500 Progressive/Interlace Series Rev: D
Eau Claire WI, 54703 Page 18 of 33