User's Manual

The remote fails to operate
If the LED does not light up when a remote control button is pressed, change the battery
BATTERY REPLACEMENT
Using a small flat-head screwdriver, to pry apart the two halves of the remote case take care not to disturb the
circuit board. Remove the old batteries whilst paying attention to the orientation of the positive and negative
terminals. Insert new batteries in identical fashion to the original and re-assemble remote. Snap the case
halves back together. For further information, please contact your local Cyclops service centre.
Remote battery type CR2016.
SPECIFICATIONS
Manufactured by Dynamco Pty Ltd
Model number Paralyser 275
Standards met AS/NZS 4601:1999
Supply voltage +12VDC
Current consumption <10 mA (while armed)
- 5 -
REMOVE BATTERIES
IN THIS DIRECTION
CASE TOP
MEMBRANE
PCB
CASE BOTTOM
KEYRING