Installation Guide

8) Note the sensor Ohms resistance value written on the sensor
cable.
9) Attach the cable. There is a notch to line up the connectors then
there is a “click” when the connector is completely tight.
10) Install the (3) foam bodies with Velcro
straps. The cable goes inside the gap of the
bottom foam body before the Velcro strap is
tightened.
11) Install the
white waterproof
membrane cloth
with a nylon wire –
tie or Velcro strap
at the top and at the
bottom.
12) Install bubble shield on the stem below
the sensor with tape. Try to insulate at least
two sensor lengths or more of stem below
where the sensor is installed.
13) Install bubble shield around the entire
sensor and tape in place, especially at
the top. Leave the bottom of the bubble
wrap un-taped for ventilation.