User manual
DECAL:
DY8967
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
CENTER OF GRAVITY(C.G.)
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
Control Throw Setting Suggestion
Elevator Aileron Rudder
14.8V 2200mAh
Li-Po, 25C
(12x6)
ESC-40A
ESC-40A
Lithium-polymer Battery
2200mAh 14.8V
25C Discharge
Rechargeable Cells
Use li-po charger only
MOTOR
95 100 95 100
DYR-2001 2.4G Receiver
DY-6015 14.8V 2200mAh
25C Battery
BM3720A-KV650
Brushless Motor
BM3720A-KV650-Shaft
Motor Shaft
SPARE PART LIST:
C188-01 Fuselage
C188-02 Main Wing
C188-03
Middle Wing Set
C188-04 Elevator
C188-09 Cowl
C188-10 Canopy
C188
-11 Spinner
C188-12 Landing Gear
C188-17 Tail wheel
C188-18 Screw set
20
3 4 5 6
7 8
9
10
11
12
13
14
15
16
17
18
19 21 22
Apply glue and attach the wing sections.
Glue the wing tips.Glue the scale antenna.
Insert the horizontal stabilizer and vertical
stabilizer in place.
Secure the stabilizers with PA2.3*20mm
screw.
Install elevator push rod as shown. Install rudder push rod as shown.
Glue the glass fiber sheets in the wing.
Attach the wires/springs to the rear wheel
and plastic pivot arm as per the photo.
Open the canopy this way.
1
5 6
78
3 4 2
比例 1.000
Glue the pilot. Glue the canopy.
Install the propeller.
Install spinner with PA2.5*8mm screws.
C188-13 Plastic Parts
C188-14 Servo Horn C188-15 Decal
DYB-05 Pilot
Connect the aileron servos with Y wires.
Push undercarriage mounting plate in
position and fix in place with PWM3*25
mm screws.
Fix the wing on the fuselage with PM3*25
mm screw.
Secure the wing struts with PA2.3*8mm
screw.
Remove the tape from the undercarriage
cover. press the cover in position as
shown.
C188-05
Vertical Stabilizer
C188-06 Wing tips
C188-08 Wing struts
C188-07 Foam for wing struts.
DY-1007 9g Servo
DYT-2001 4CH Transmitter
DYE-1004 40A ESC
DYP-1018 12*6 Propeller
Secure elevator servo horn with PM2*14
mm screw.
Secure the rear wheel with PA2*6mm screw.
Secure rvdder servo horn with PM2*16mm
screw.
C188-16 Battery cover
DY-3006 Motor Mount