User Manual

DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
CENTER OF GRAVITY(C.G.)
DECAL:
DY8960
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
SPARE PART LIST:
ASSEMBLY:
Fix struts of landing gear
with PA2.5x10mmscrews.
Glue the scale engine and
exhaust in place.
Fix the canopy by glue.
Install the landing gear with
PA2.5x8mm screws.
Glue the scale machine
guns in place.
11
13
9
14
10
12
Fix the upper wing with
M2*8mm screws.
Put the upper wing on wing
struts as shown.
Install side wing struts with
M2*8mm screws.
Connect the aileron servos
with Y wires.
Install wing struts with
PA2.5*8mm screws.
Fix the pilot by glue.
17
19
15
2016
18
Install rudder push rod
as shown.
Glue the scale plastic parts.Install the elevator with
M.3*8mm screws.
Fix the stabilizers with
PA2.3*20mm screw.
Install elevator push rod
as shown .
Fix the upper wing with
PM2*8mm screws.
23
25
21
26
22 24
Install the spinner with
PM3*8mm screws.
Install the propeller.
Install the scale plastic parts.
Install the scale plastic parts. Put the battery in position. Install the battery cover.
Fix wheels with set screw
M3x3.
Fix struts of landing gear
with PA2.5x10mm screws.
Install the lower wing with
PA2.3x20mm screws.
60 65
The ideal C.G. position is 60~65mm behind the
leading edge measured at where the wing meets
the fuselage.In order to obtain the C.G.
specified,add weight to the fuselage or move the
battery position. Check the C.G. before flying.
60 65
Suggest Control Throw Setting
Elevator Aileron Rudder
14.8V 2200mAh
Li-Po 25C
(13x6)
ESC-40A
ESC-40A
2200mAh 14.8V
25C Discharge
Lithium-polymer Battery
Rechargeable Cells
Use li-po charger only
ADVa-18 Motor Mount
ADVa-17 Plastic Tab
ADVa-19 Screw set